SUMMARY Adding a DLT from Quantum on E3000 running 2.5.1

Stephen Johnston (sjohnsto@eso.org)
Mon, 15 Dec 1997 18:27:30 +0100

Thanks for all the help apparently the st.conf file was correct

particular interest in the attached message as our networker
installation runs badly as well. I don't know if the patch helped as
ultimately it turned out the SCSI id selector on the device was broken.

Tahnks again.

Regards,

Stpehen.

S Johnston wrote:
>
> Can some confirm this is the correct entry in the /kernel/drv/st.conf
> file for this device?
>
> tape-config-list=
> "SUN DLT4000", "Quantum DLT 4000", "QDLT";
> QDLT =1,0x36,0,0xD639,4,0x80,0x81,0x82,0x83,2;
>

Don't know if you have got many reply yet, probably knowing this list.
We usually
get things the next day here in Australia.

You need to put in the patch 103857-08. It fixed all of our DLT
problems. We
use Networker and fsf would take 1 hour, now they take seconds!

I looked at the st.conf file ( the patch changed it) and it looks like:

"Quantum DLT4000", "Quantum DLT 4000", "DLT4",
DLT4 = 1,0x38,0,0xd639,4,0x80,0x80,0x80,0x81,3;

It is a "Sun" DLT.

-- 
Stephen Johnston				Phone: +49 89 32006 443
UNIX Sysadmin					Fax:   +49 89 32006 380
SERCO GmbH at European Southern Observatory
Karl-Schwarzschild-Strasse 2			mailto:sjohnsto@eso.org
D-85748 Garching bei Muenchen			http://www.eso.org